Motorcycle tire review and fitment for Yamaha TT 600 R
Motorcycle tire review and tips especially for Yamaha TT 600 R tires
- Top It Off: The valve stem cap should be securely fastened on the stem, because it's an important part of your tire's sealing system. It'll give you extra security at high speeds, when centrifugal force can conspire to open the valve inside the stem.
- Don't Mix and Match: Never run two tires of differing construction. We can't stress this enough, and this rule applies to bias-plies vs. radials as well as tubeless and tube-type tires--even bias-ply vs. bias-belted tires. The results can be disastrous.
- Don't Scrimp: If you replace your tires, make sure you replace the tubes, too. Some manufacturers even recommend that you change both tires at the same time, even if they wear differently.
- When oil is changed, it’s a good idea to check tire pressure and inflate to at least recommended manufacturer suggested pressure or higher so the tires run cooler and have less rolling resistance. This will result in better fuel economy and higher mileage for your tires. It also helps avoid irregular tread wear on the tires.
- Tubes should always be replaced as these will wear just like the tire itself. When installing tubes be sure to locate the valve stem retaining nut all the way to the top of the valve stem so that it touches the cap. This way if the tube spins inside the tire you can see this by the tilt of the stem before the stem is torn from the tube itself. On tubeless tires always inspect the valve stem for cracks and dried out rubber, since these can crack over time and leak air. This thinking applies to car valve stems as well.
>> OK, but what do these numbers and letters mean? <<
:: Help me identifying the motorbike tire codes! ::
:: Help me identifying the motorbike tire codes! ::
| < Prev | Next > |
|---|