Motorcycle tire review and fitment for Yamaha FZ 6 Fazer S2 2007-2008
Motorcycle tire review and tips especially for Yamaha FZ 6 Fazer S2 2007-2008 tires
- Don't Mix and Match: Never run two tires of differing construction. We can't stress this enough, and this rule applies to bias-plies vs. radials as well as tubeless and tube-type tires--even bias-ply vs. bias-belted tires. The results can be disastrous.
- Scuff 'Em Up: Optimal grip is obtained only after the tread surface has been ridden on, so go into those first few twisties with a bit of caution. The suggested break-in distance is usually 100 or so miles. After that, check the tire's pressure again!
- Don't Scrimp: If you replace your tires, make sure you replace the tubes, too. Some manufacturers even recommend that you change both tires at the same time, even if they wear differently.
- Hydroplaning is the effect when the tire rides up onto the water surface of the road. What effects this is both the remaining thread depth, speed of the motorcycle and the amount of water on the road surface. In wet weather slow down and before going on a long ride for safety sake replace your tires if they are near the wear bars...its your skin.
- Motorcycle tires work in much more brutal environment then car tires. Because of many factors such as load carried, horsepower and torque produced, and this being applied to a contact surface that is very small by comparison, one can understand why the tires are not only expensive but also work in a much more demanding environment. Therefore keeping the tire pressure correct and routine tire inspection is critical.
>> OK, but what do these numbers and letters mean? <<
:: Help me identifying the motorbike tire codes! ::
:: Help me identifying the motorbike tire codes! ::
| < Prev | Next > |
|---|