Motorcycle tire review and fitment for Triumph Daytona 955 i (twin sided swingarm) 2002-2002

Motorcycle tire review and specification for Triumph Daytona 955 i (twin sided swingarm) 2002-2002
#	Motorcycle tire review and specification	Tire tube type	We recommend	Image (click to enlarge)	Ad
1	Front Tire: 120/70ZR17 58W	Tubeless(TL)	Dunlop Sportmax Roadsmart Front Sport Touring / Trail
	Rear Tire: 180/55ZR17 73W	Tubeless(TL)	Dunlop Sportmax Roadsmart Sport Touring / Trail
2	Front Tire: 120/70ZR17 58W	Tubeless(TL)	Dunlop Sportmax Qualifier D209F Supersport
	Rear Tire: 180/55ZR17 73W	Tubeless(TL)	Dunlop Sportmax Qualifier D209 Supersport

Motorcycle tire review and tips especially for Triumph Daytona 955 i (twin sided swingarm) 2002-2002 tires

• Step in Line: Pay close attention to alignment--shaft drive bikes have no adjustment, but if you have a chain or belt, check the position of your tires. Proper alignment ensures better handling and longer wear.


• Scuff 'Em Up: Optimal grip is obtained only after the tread surface has been ridden on, so go into those first few twisties with a bit of caution. The suggested break-in distance is usually 100 or so miles. After that, check the tire's pressure again!


• Check tire pressure at least once a month for cars, once a week for motorcycles. Tires can lose up to a pound a month of air pressure. Consistency is the key. A sudden drop in pressure is noticeable with regular pressure checks. E.g., 40, 39, 40 then 30 psi indicates a leak or puncture or other type of problem. It could be as simple as a bad valve stem or bent rim or something more serious such as internal tire failure.


• When riding for long distances monitor tire pressure every morning when tires are cold. Then check tire pressure after a few hours of use. More than a 10% increase in inflation means the tire is working too hard. Lighten the load, decrease speed, or add air to the tires so they run cooler.


• Tubes should always be replaced as these will wear just like the tire itself. When installing tubes be sure to locate the valve stem retaining nut all the way to the top of the valve stem so that it touches the cap. This way if the tube spins inside the tire you can see this by the tilt of the stem before the stem is torn from the tube itself. On tubeless tires always inspect the valve stem for cracks and dried out rubber, since these can crack over time and leak air. This thinking applies to car valve stems as well.

>> OK, but what do these numbers and letters mean? <<
:: Help me identifying the motorbike tire codes! ::