Motorcycle tire reviews

Motorcycle tire review Suzuki GSX-R 250 1989 on

#	Motorcycle tire review and specification	Tire tube type	We recommend
Motorcycle tire review and specification for Suzuki GSX-R 250 1989 on
1	Front Tire: 110/70R17 54H	Tubeless(TL)	Dunlop Sportmax GPR Alpha-10F Hypersport / Supersport
1	Rear Tire: 140/60R18 64H	Tubeless(TL)	Dunlop Sportmax GPR Alpha-10 Hypersport / Supersport

Air It Out: Check tire pressure every chance you get. There's probably no simpler procedure that's more important and more ignored by bikers of every stripe. The air, not the carcass, supports the bike, and underinflation is a tire's number one enemy. (Make sure the tires are cool when you take the reading.) Contrary to most belief of riders that lesser pressure tire offer more grip on wet roads---For a better tractrion in wet conditions, increase pressures by about 10 percent. Unsure of what the pressure is supposed to be? Look for a sticker somewhre on the bike. It is also probably on the VIN (serial number) plate hear the steering head with the gross vehicle weight rating (GVWR) and gross axle weight ratings (GAWR) information. The simplest and most important thing you can do for your tires' health and your safety is keep them, inflated to the designated pressure.

When riding for long distances monitor tire pressure every morning when tires are cold. Then check tire pressure after a few hours of use. More than a 10% increase in inflation means the tire is working too hard. Lighten the load, decrease speed, or add air to the tires so they run cooler.

When oil is changed, it’s a good idea to check tire pressure and inflate to at least recommended manufacturer suggested pressure or higher so the tires run cooler and have less rolling resistance. This will result in better fuel economy and higher mileage for your tires. It also helps avoid irregular tread wear on the tires.

Remember cold weather means air in the tires contracts and may require additional air. High temperatures, hot or rough road surfaces, high speeds and heavy loads all cause the tire to work harder and hotter. Make sure tire pressure is sufficient to deal with these conditions. Also under inflation is the number one cause of tire failure.

Tubes should always be replaced as these will wear just like the tire itself. When installing tubes be sure to locate the valve stem retaining nut all the way to the top of the valve stem so that it touches the cap. This way if the tube spins inside the tire you can see this by the tilt of the stem before the stem is torn from the tube itself. On tubeless tires always inspect the valve stem for cracks and dried out rubber, since these can crack over time and leak air. This thinking applies to car valve stems as well.