Motorcycle tire review and fitment for Suzuki GSX 400 F Kantana 1981-1985
Motorcycle tire review and tips especially for Suzuki GSX 400 F Kantana 1981-1985 tires
- Air It Out: Check tire pressure every chance you get. There's probably no simpler procedure that's more important and more ignored by bikers of every stripe. The air, not the carcass, supports the bike, and underinflation is a tire's number one enemy. (Make sure the tires are cool when you take the reading.) Contrary to most belief of riders that lesser pressure tire offer more grip on wet roads---For a better tractrion in wet conditions, increase pressures by about 10 percent. Unsure of what the pressure is supposed to be? Look for a sticker somewhre on the bike. It is also probably on the VIN (serial number) plate hear the steering head with the gross vehicle weight rating (GVWR) and gross axle weight ratings (GAWR) information. The simplest and most important thing you can do for your tires' health and your safety is keep them, inflated to the designated pressure.
- Don't Mix and Match: Never run two tires of differing construction. We can't stress this enough, and this rule applies to bias-plies vs. radials as well as tubeless and tube-type tires--even bias-ply vs. bias-belted tires. The results can be disastrous.
- Use a digital pressure gauge if possible or ensure your pencil stick gauge is accurate. Look into a tire sensor to warn of low air.
- Eyeballing tires for under inflation or over inflation is not a good idea, particularly on a motorcycle. A bike on a center stand and with no riders on it could be missing half the weight or more the tires will end up supporting. In addition, it is necessary to get down and examine tires under the fender to see if there is any tire damage. With only a few small inches supporting the load on two tires versus a much larger contact patch on 4 tires it’s a much riskier proposition taking a chance with motorcycle tires. Check also for cracking on the sidewalls, in the grooves, stones or cuts.
- When inspecting your tires check the tread wear indicators (TWI), which are noted by the TWI (some tires may display logos etc in place of TWI) marking located on the tire sidewall. Look towards the center of the tire to locate the actual tire wear bar which will be located in the tread groove itself, as a raised bar. When the tire is worn to this indicator it is time for a new tire. We have actual samples of worn tires to show you the amount of skin left between you and the road so to say. It is scary. The remaining amount of rubber is actually less than is apparent from the outside.
>> OK, but what do these numbers and letters mean? <<
:: Help me identifying the motorbike tire codes! ::
:: Help me identifying the motorbike tire codes! ::
| < Prev | Next > |
|---|