Motorcycle tire review and fitment for Suzuki DR-Z 250
Motorcycle tire review and tips especially for Suzuki DR-Z 250 tires
- Scuff 'Em Up: Optimal grip is obtained only after the tread surface has been ridden on, so go into those first few twisties with a bit of caution. The suggested break-in distance is usually 100 or so miles. After that, check the tire's pressure again!
- When riding for long distances monitor tire pressure every morning when tires are cold. Then check tire pressure after a few hours of use. More than a 10% increase in inflation means the tire is working too hard. Lighten the load, decrease speed, or add air to the tires so they run cooler.
- Never inflate a tire beyond the maximum inflation as noted on the tire sidewall. Inflate your tires when they are cold, and be aware that a cooler day may also require you to recheck the inflation pressures due to a change in outside air temperature.
- Tubes should always be replaced as these will wear just like the tire itself. When installing tubes be sure to locate the valve stem retaining nut all the way to the top of the valve stem so that it touches the cap. This way if the tube spins inside the tire you can see this by the tilt of the stem before the stem is torn from the tube itself. On tubeless tires always inspect the valve stem for cracks and dried out rubber, since these can crack over time and leak air. This thinking applies to car valve stems as well.
- Do not apply any type of tire dressing to the sidewall or worse to the tread area of the tire, it is very slippery. Use only approved tires for your model of bike.
>> OK, but what do these numbers and letters mean? <<
:: Help me identifying the motorbike tire codes! ::
:: Help me identifying the motorbike tire codes! ::
| < Prev | Next > |
|---|