Motorcycle tire review and fitment for Suzuki AN 400 Burgman 1999-2006

Motorcycle tire review and specification for Suzuki AN 400 Burgman 1999-2006
#	Motorcycle tire review and specification	Tire tube type	We recommend	Image (click to enlarge)	Ad
1	Front Tire: 110/90-13 56P	Tubeless(TL)	Dunlop Run Scoot 207F RS Scooter Bias-Ply
	Rear Tire: 130/70-13 63P	Tubeless(TL)	Dunlop Run Scoot 207 RS Scooter Bias-Ply

Motorcycle tire review and tips especially for Suzuki AN 400 Burgman 1999-2006 tires

• Air It Out: Check tire pressure every chance you get. There's probably no simpler procedure that's more important and more ignored by bikers of every stripe. The air, not the carcass, supports the bike, and underinflation is a tire's number one enemy. (Make sure the tires are cool when you take the reading.) Contrary to most belief of riders that lesser pressure tire offer more grip on wet roads---For a better tractrion in wet conditions, increase pressures by about 10 percent. Unsure of what the pressure is supposed to be? Look for a sticker somewhre on the bike. It is also probably on the VIN (serial number) plate hear the steering head with the gross vehicle weight rating (GVWR) and gross axle weight ratings (GAWR) information. The simplest and most important thing you can do for your tires' health and your safety is keep them, inflated to the designated pressure.


• Look Before You Crank: Before you saddle up, take a moment to visually inspect your tires. We can't tell you how many times we've pulled out screws or nails before a ride, thus preventing almost certain tire failure. Once you're on the road, it'll be too late.


• It is good idea to attend one of our tech sessions to learn how to plug the tires with a plug kit if that nasty nail has found its way into the tire carcass. That way if it does occur this temporary repair can be quickly accomplished on the roadside.


• Tubes should always be replaced as these will wear just like the tire itself. When installing tubes be sure to locate the valve stem retaining nut all the way to the top of the valve stem so that it touches the cap. This way if the tube spins inside the tire you can see this by the tilt of the stem before the stem is torn from the tube itself. On tubeless tires always inspect the valve stem for cracks and dried out rubber, since these can crack over time and leak air. This thinking applies to car valve stems as well.


• Do not apply any type of tire dressing to the sidewall or worse to the tread area of the tire, it is very slippery. Use only approved tires for your model of bike.

>> OK, but what do these numbers and letters mean? <<
:: Help me identifying the motorbike tire codes! ::