Motorcycle tire review and fitment for KTM 125 Euro 1996
Motorcycle tire review and tips especially for KTM 125 Euro 1996 tires
- Top It Off: The valve stem cap should be securely fastened on the stem, because it's an important part of your tire's sealing system. It'll give you extra security at high speeds, when centrifugal force can conspire to open the valve inside the stem.
- Don't Mix and Match: Never run two tires of differing construction. We can't stress this enough, and this rule applies to bias-plies vs. radials as well as tubeless and tube-type tires--even bias-ply vs. bias-belted tires. The results can be disastrous.
- Scuff 'Em Up: Optimal grip is obtained only after the tread surface has been ridden on, so go into those first few twisties with a bit of caution. The suggested break-in distance is usually 100 or so miles. After that, check the tire's pressure again!
- Use a digital pressure gauge if possible or ensure your pencil stick gauge is accurate. Look into a tire sensor to warn of low air.
- Hydroplaning is the effect when the tire rides up onto the water surface of the road. What effects this is both the remaining thread depth, speed of the motorcycle and the amount of water on the road surface. In wet weather slow down and before going on a long ride for safety sake replace your tires if they are near the wear bars...its your skin.
>> OK, but what do these numbers and letters mean? <<
:: Help me identifying the motorbike tire codes! ::
:: Help me identifying the motorbike tire codes! ::
| < Prev | Next > |
|---|