Motorcycle tire reviews

Motorcycle tire review Kawasaki EN 400 1994 on

#	Motorcycle tire review and specification	Tire tube type	We recommend
Motorcycle tire review and specification for Kawasaki EN 400 1994 on
1	Front Tire: 100/90-19 57H	Tubeless(TL)	Dunlop D404F Road bias Custom Touring
1	Rear Tire: 140/90-15 70H	Tubeless(TL)	Dunlop D404 Road bias Custom Touring

Air It Out: Check tire pressure every chance you get. There's probably no simpler procedure that's more important and more ignored by bikers of every stripe. The air, not the carcass, supports the bike, and underinflation is a tire's number one enemy. (Make sure the tires are cool when you take the reading.) Contrary to most belief of riders that lesser pressure tire offer more grip on wet roads---For a better tractrion in wet conditions, increase pressures by about 10 percent. Unsure of what the pressure is supposed to be? Look for a sticker somewhre on the bike. It is also probably on the VIN (serial number) plate hear the steering head with the gross vehicle weight rating (GVWR) and gross axle weight ratings (GAWR) information. The simplest and most important thing you can do for your tires' health and your safety is keep them, inflated to the designated pressure.

When oil is changed, it’s a good idea to check tire pressure and inflate to at least recommended manufacturer suggested pressure or higher so the tires run cooler and have less rolling resistance. This will result in better fuel economy and higher mileage for your tires. It also helps avoid irregular tread wear on the tires.

Motorcycle tires work in much more brutal environment then car tires. Because of many factors such as load carried, horsepower and torque produced, and this being applied to a contact surface that is very small by comparison, one can understand why the tires are not only expensive but also work in a much more demanding environment. Therefore keeping the tire pressure correct and routine tire inspection is critical.

It is good idea to attend one of our tech sessions to learn how to plug the tires with a plug kit if that nasty nail has found its way into the tire carcass. That way if it does occur this temporary repair can be quickly accomplished on the roadside.

Tubes should always be replaced as these will wear just like the tire itself. When installing tubes be sure to locate the valve stem retaining nut all the way to the top of the valve stem so that it touches the cap. This way if the tube spins inside the tire you can see this by the tilt of the stem before the stem is torn from the tube itself. On tubeless tires always inspect the valve stem for cracks and dried out rubber, since these can crack over time and leak air. This thinking applies to car valve stems as well.