Motorcycle tire reviews

Motorcycle tire review Kawasaki GPZ 600 R 1986 on

#	Motorcycle tire review and specification	Tire tube type	We recommend
Motorcycle tire review and specification for Kawasaki GPZ 600 R 1986 on
1	Front Tire: 110/90-16 59V	Tubeless(TL)	Dunlop Arrowmax GT501F General Road Tires
1	Rear Tire: 130/90-16 67V	Tubeless(TL)	Dunlop Arrowmax GT501 General Road Tires

Air It Out: Check tire pressure every chance you get. There's probably no simpler procedure that's more important and more ignored by bikers of every stripe. The air, not the carcass, supports the bike, and underinflation is a tire's number one enemy. (Make sure the tires are cool when you take the reading.) Contrary to most belief of riders that lesser pressure tire offer more grip on wet roads---For a better tractrion in wet conditions, increase pressures by about 10 percent. Unsure of what the pressure is supposed to be? Look for a sticker somewhre on the bike. It is also probably on the VIN (serial number) plate hear the steering head with the gross vehicle weight rating (GVWR) and gross axle weight ratings (GAWR) information. The simplest and most important thing you can do for your tires' health and your safety is keep them, inflated to the designated pressure.

When oil is changed, it’s a good idea to check tire pressure and inflate to at least recommended manufacturer suggested pressure or higher so the tires run cooler and have less rolling resistance. This will result in better fuel economy and higher mileage for your tires. It also helps avoid irregular tread wear on the tires.

Remember cold weather means air in the tires contracts and may require additional air. High temperatures, hot or rough road surfaces, high speeds and heavy loads all cause the tire to work harder and hotter. Make sure tire pressure is sufficient to deal with these conditions. Also under inflation is the number one cause of tire failure.

Eyeballing tires for under inflation or over inflation is not a good idea, particularly on a motorcycle. A bike on a center stand and with no riders on it could be missing half the weight or more the tires will end up supporting. In addition, it is necessary to get down and examine tires under the fender to see if there is any tire damage. With only a few small inches supporting the load on two tires versus a much larger contact patch on 4 tires it’s a much riskier proposition taking a chance with motorcycle tires. Check also for cracking on the sidewalls, in the grooves, stones or cuts.

Tubes should always be replaced as these will wear just like the tire itself. When installing tubes be sure to locate the valve stem retaining nut all the way to the top of the valve stem so that it touches the cap. This way if the tube spins inside the tire you can see this by the tilt of the stem before the stem is torn from the tube itself. On tubeless tires always inspect the valve stem for cracks and dried out rubber, since these can crack over time and leak air. This thinking applies to car valve stems as well.