Motorcycle tire review and fitment for Honda CB 900 F Hornet 2002-2008

Motorcycle tire review and specification for Honda CB 900 F Hornet 2002-2008
#	Motorcycle tire review and specification	Tire tube type	We recommend	Image (click to enlarge)	Ad
1	Front Tire: 120/70ZR17 58W	Tubeless(TL)	Dunlop Sportmax Roadsmart Front Sport Touring / Trail
	Rear Tire: 180/55ZR17 73W	Tubeless(TL)	Dunlop Sportmax Roadsmart Sport Touring / Trail
2	Front Tire: 120/70ZR17 58W	Tubeless(TL)	Dunlop Sportmax Qualifier RR Hypersport
	Rear Tire: 180/55ZR17 73W	Tubeless(TL)	Dunlop Sportmax Qualifier RR Hypersport
3	Front Tire: 120/70ZR17 58W	Tubeless(TL)	Dunlop Sportmax Qualifier D209F Supersport
	Rear Tire: 180/55ZR17 73W	Tubeless(TL)	Dunlop Sportmax Qualifier D209 Supersport

Motorcycle tire review and tips especially for Honda CB 900 F Hornet 2002-2008 tires

• Look Before You Crank: Before you saddle up, take a moment to visually inspect your tires. We can't tell you how many times we've pulled out screws or nails before a ride, thus preventing almost certain tire failure. Once you're on the road, it'll be too late.


• Check tire pressure at least once a month for cars, once a week for motorcycles. Tires can lose up to a pound a month of air pressure. Consistency is the key. A sudden drop in pressure is noticeable with regular pressure checks. E.g., 40, 39, 40 then 30 psi indicates a leak or puncture or other type of problem. It could be as simple as a bad valve stem or bent rim or something more serious such as internal tire failure.


• When inspecting your tires check the tread wear indicators (TWI), which are noted by the TWI (some tires may display logos etc in place of TWI) marking located on the tire sidewall. Look towards the center of the tire to locate the actual tire wear bar which will be located in the tread groove itself, as a raised bar. When the tire is worn to this indicator it is time for a new tire. We have actual samples of worn tires to show you the amount of skin left between you and the road so to say. It is scary. The remaining amount of rubber is actually less than is apparent from the outside.


• Tubes should always be replaced as these will wear just like the tire itself. When installing tubes be sure to locate the valve stem retaining nut all the way to the top of the valve stem so that it touches the cap. This way if the tube spins inside the tire you can see this by the tilt of the stem before the stem is torn from the tube itself. On tubeless tires always inspect the valve stem for cracks and dried out rubber, since these can crack over time and leak air. This thinking applies to car valve stems as well.


• Do not apply any type of tire dressing to the sidewall or worse to the tread area of the tire, it is very slippery. Use only approved tires for your model of bike.

>> OK, but what do these numbers and letters mean? <<
:: Help me identifying the motorbike tire codes! ::