Motorcycle tire reviews

Motorcycle tire review Honda CB 500 K0-K2

#	Motorcycle tire review and specification	Tire tube type	We recommend
Motorcycle tire review and specification for Honda CB 500 K0-K2
1	Front Tire: 3.2-19 54H	Tubed Tire(TT)	Dunlop Arrowmax GT501F General Road Tires
1	Rear Tire: 4.0-18 64H	Tubed Tire(TT)	Dunlop Arrowmax GT501 General Road Tires

Air It Out: Check tire pressure every chance you get. There's probably no simpler procedure that's more important and more ignored by bikers of every stripe. The air, not the carcass, supports the bike, and underinflation is a tire's number one enemy. (Make sure the tires are cool when you take the reading.) Contrary to most belief of riders that lesser pressure tire offer more grip on wet roads---For a better tractrion in wet conditions, increase pressures by about 10 percent. Unsure of what the pressure is supposed to be? Look for a sticker somewhre on the bike. It is also probably on the VIN (serial number) plate hear the steering head with the gross vehicle weight rating (GVWR) and gross axle weight ratings (GAWR) information. The simplest and most important thing you can do for your tires' health and your safety is keep them, inflated to the designated pressure.

Top It Off: The valve stem cap should be securely fastened on the stem, because it's an important part of your tire's sealing system. It'll give you extra security at high speeds, when centrifugal force can conspire to open the valve inside the stem.

Don't Mix and Match: Never run two tires of differing construction. We can't stress this enough, and this rule applies to bias-plies vs. radials as well as tubeless and tube-type tires--even bias-ply vs. bias-belted tires. The results can be disastrous.

Check tire pressure at least once a month for cars, once a week for motorcycles. Tires can lose up to a pound a month of air pressure. Consistency is the key. A sudden drop in pressure is noticeable with regular pressure checks. E.g., 40, 39, 40 then 30 psi indicates a leak or puncture or other type of problem. It could be as simple as a bad valve stem or bent rim or something more serious such as internal tire failure.

When inspecting your tires check the tread wear indicators (TWI), which are noted by the TWI (some tires may display logos etc in place of TWI) marking located on the tire sidewall. Look towards the center of the tire to locate the actual tire wear bar which will be located in the tread groove itself, as a raised bar. When the tire is worn to this indicator it is time for a new tire. We have actual samples of worn tires to show you the amount of skin left between you and the road so to say. It is scary. The remaining amount of rubber is actually less than is apparent from the outside.