Motorcycle tire review and fitment for BMW R 100 1980-1984
Motorcycle tire review and tips especially for BMW R 100 1980-1984 tires
- Don't Mix and Match: Never run two tires of differing construction. We can't stress this enough, and this rule applies to bias-plies vs. radials as well as tubeless and tube-type tires--even bias-ply vs. bias-belted tires. The results can be disastrous.
- Scuff 'Em Up: Optimal grip is obtained only after the tread surface has been ridden on, so go into those first few twisties with a bit of caution. The suggested break-in distance is usually 100 or so miles. After that, check the tire's pressure again!
- Use a digital pressure gauge if possible or ensure your pencil stick gauge is accurate. Look into a tire sensor to warn of low air.
- Motorcycle tires work in much more brutal environment then car tires. Because of many factors such as load carried, horsepower and torque produced, and this being applied to a contact surface that is very small by comparison, one can understand why the tires are not only expensive but also work in a much more demanding environment. Therefore keeping the tire pressure correct and routine tire inspection is critical.
- Do not apply any type of tire dressing to the sidewall or worse to the tread area of the tire, it is very slippery. Use only approved tires for your model of bike.
>> OK, but what do these numbers and letters mean? <<
:: Help me identifying the motorbike tire codes! ::
:: Help me identifying the motorbike tire codes! ::
| < Prev | Next > |
|---|