Motorcycle tire reviews

Motorcycle tire review BMW K 100 RS 4v 1990-1992

#	Motorcycle tire review and specification	Tire tube type	We recommend
Motorcycle tire review and specification for BMW K 100 RS 4v 1990-1992
1	Front Tire: 120/70ZR17 58W	Tubeless(TL)	Dunlop Sportmax Roadsmart Front Sport Touring / Trail
1	Rear Tire: 160/60ZR18 70W	Tubeless(TL)	Dunlop Sportmax Roadsmart Sport Touring / Trail

Air It Out: Check tire pressure every chance you get. There's probably no simpler procedure that's more important and more ignored by bikers of every stripe. The air, not the carcass, supports the bike, and underinflation is a tire's number one enemy. (Make sure the tires are cool when you take the reading.) Contrary to most belief of riders that lesser pressure tire offer more grip on wet roads---For a better tractrion in wet conditions, increase pressures by about 10 percent. Unsure of what the pressure is supposed to be? Look for a sticker somewhre on the bike. It is also probably on the VIN (serial number) plate hear the steering head with the gross vehicle weight rating (GVWR) and gross axle weight ratings (GAWR) information. The simplest and most important thing you can do for your tires' health and your safety is keep them, inflated to the designated pressure.

Soap It Up: Most tire manufacturers recommend that the only substance used to keep rubber shiny should be good old soap and water. Many alleged protectants actually promote premature cracking and finish deterioration. Make sure you wipe off any lube, brake fluid or gas promptly, too.

When oil is changed, it’s a good idea to check tire pressure and inflate to at least recommended manufacturer suggested pressure or higher so the tires run cooler and have less rolling resistance. This will result in better fuel economy and higher mileage for your tires. It also helps avoid irregular tread wear on the tires.

Remember cold weather means air in the tires contracts and may require additional air. High temperatures, hot or rough road surfaces, high speeds and heavy loads all cause the tire to work harder and hotter. Make sure tire pressure is sufficient to deal with these conditions. Also under inflation is the number one cause of tire failure.

When inspecting your tires check the tread wear indicators (TWI), which are noted by the TWI (some tires may display logos etc in place of TWI) marking located on the tire sidewall. Look towards the center of the tire to locate the actual tire wear bar which will be located in the tread groove itself, as a raised bar. When the tire is worn to this indicator it is time for a new tire. We have actual samples of worn tires to show you the amount of skin left between you and the road so to say. It is scary. The remaining amount of rubber is actually less than is apparent from the outside.