Motorcycle tire review and fitment for Aprilia Tuareg Wind 125 1990-1991

Motorcycle tire review and specification for Aprilia Tuareg Wind 125 1990-1991
#	Motorcycle tire review and specification	Tire tube type	We recommend	Image (click to enlarge)	Ad
1	Front Tire: 90/90-21 54S	Tubed Tire(TT)	Dunlop Trailmax front Trail
	Rear Tire: 120/90-17 64S	Tubed Tire(TT)	Dunlop Trailmax Trail

Motorcycle tire review and tips especially for Aprilia Tuareg Wind 125 1990-1991 tires

• Air It Out: Check tire pressure every chance you get. There's probably no simpler procedure that's more important and more ignored by bikers of every stripe. The air, not the carcass, supports the bike, and underinflation is a tire's number one enemy. (Make sure the tires are cool when you take the reading.) Contrary to most belief of riders that lesser pressure tire offer more grip on wet roads---For a better tractrion in wet conditions, increase pressures by about 10 percent. Unsure of what the pressure is supposed to be? Look for a sticker somewhre on the bike. It is also probably on the VIN (serial number) plate hear the steering head with the gross vehicle weight rating (GVWR) and gross axle weight ratings (GAWR) information. The simplest and most important thing you can do for your tires' health and your safety is keep them, inflated to the designated pressure.


• Soap It Up: Most tire manufacturers recommend that the only substance used to keep rubber shiny should be good old soap and water. Many alleged protectants actually promote premature cracking and finish deterioration. Make sure you wipe off any lube, brake fluid or gas promptly, too.


• When inspecting your tires check the tread wear indicators (TWI), which are noted by the TWI (some tires may display logos etc in place of TWI) marking located on the tire sidewall. Look towards the center of the tire to locate the actual tire wear bar which will be located in the tread groove itself, as a raised bar. When the tire is worn to this indicator it is time for a new tire. We have actual samples of worn tires to show you the amount of skin left between you and the road so to say. It is scary. The remaining amount of rubber is actually less than is apparent from the outside.


• Motorcycle tires work in much more brutal environment then car tires. Because of many factors such as load carried, horsepower and torque produced, and this being applied to a contact surface that is very small by comparison, one can understand why the tires are not only expensive but also work in a much more demanding environment. Therefore keeping the tire pressure correct and routine tire inspection is critical.


• Tubes should always be replaced as these will wear just like the tire itself. When installing tubes be sure to locate the valve stem retaining nut all the way to the top of the valve stem so that it touches the cap. This way if the tube spins inside the tire you can see this by the tilt of the stem before the stem is torn from the tube itself. On tubeless tires always inspect the valve stem for cracks and dried out rubber, since these can crack over time and leak air. This thinking applies to car valve stems as well.

>> OK, but what do these numbers and letters mean? <<
:: Help me identifying the motorbike tire codes! ::